KNOWLEDGE LIBRARY

AMERICAN NATIONAL STANDARDS INSTITUTE is a good resource for the below documents and can be (or will soon be) obtainable from the online standards store, - A licensee of both SPI and B11 Standards 

www.ansi.org

  • ANSI/SPI B151.1-2007 (R2012)  Horizontal Injection Molding Machines ‑ Safety Requirements for Manufacture, Care, and Use (under revision; expected Q1 or Q2, 2014)

  • ANSI/SPI B151.29-2002 (R2012)  Safety Requirements for the Manufacture, Care and Use of Vertical Clamp Injection Molding Machines (VCIMM) (under revision; expected Q4 2013)

  •  SPI Publication No. AN116 (Aug.2001)  Recommended Guideline for Robot Injection Molding Machine Electrical Interface

  • ANSI/SPI B151.27-2013  Safety Requirements for the Integration of Robots with Injection Molding Machines (currently in final stages of revision anticipate ANSI approval in September 2013)

  • ANSI B11.19-2010  Performance Criteria for Safeguarding (this is a general safeguarding standard that applies across the broad range of machinery, not just plastics machines)

  • ANSI B11.0-2012  Safety of Machinery General Requirements and Risk Assessment (this is also a general safety standard that applies across the broad range of machinery, not just plastics machines)

The first (4) documents may also be obtained through the plasticsindustry.org website

https://store.plasticsindustry.org/source/security/member-logon.cfm?section=unknown&activesection=home

 

HEAT TRANSFER EQUIPMENT

CONVEYORS

MISCELLANEOUS

DRYING, CONVEYING & BLENDING

ROBOTS

SCREWS/BARRELS

NEGATIVE PRESSURE COOLING

 WATER

Return to Home Page